|
|
||
|
|
Tappets and pushrodsFrom: "Tserghanos, Jordan" <jordan.tserghanos@peelsb.com> Next Article (by Subject): RE: Tappets and pushrods Ken Durstine Hello, I am getting a ticking sound and I think it may be from a tappet. What = is the best way to check a tappet and if I replace them, should I do = just the bad one or all of them. What make(s) are recommended. Are the = stock ones any good. Also, I have a set of Andrews chromoly pushrods = (standard length) that I had also been using before my conversion, = should I have changed those when I did my conversion about 5000 km. ago. = My current setup is this: Thunderstorm heads Buell Domed pistons SE 1200 ignition non adjustable SE Bolt-in Cams .497's. SE Air Cleaner SE I Slip-ons =20 Jordan Regards, Jordan jtserghanos@hotmail.com NOTE:This e-mail message is intended for the named recipient(s) above, = and may contain information that is privileged, confidential and/or = exempt from disclosure under applicable law. If you have received this = message in error, or are not the named recipient(s), please do not read = the content. Instead, immediately notify the sender and delete this = e-mail message. Any unauthorized use, disclosure or distribution is = prohibited. The Peel District School Board and sender assume no = responsibility for any errors or omissions in the content or = transmission of this email. Next Article (by Subject): RE: Tappets and pushrods Ken Durstine |
|
| All text and images Copyright © 1995-2006 D. Mansfield. All rights reserved. Absolutely no reproduction allowed without prior permission from the author. Disclaimer: This page is not associated with the Harley-Davidson Motor Company in any way other than a fondness of their products. Harley-Davidson, HD, Harley, and Sportster are among the trademarks and service marks of Harley-Davidson that may appear in this Web Site and that are registered in the United States and other countries. |